Wednesday, February 24, 2010

The Land Of Nod


The nod-under on the M & M Sub. The swinging gate
for the lower level is open.

In the Bible, the land of Nod is the place where Cain was exiled after murdering his brother Abel. In popular use, the Land of Nod is a place of sleep, as in to “nod off.” It’s also used as a way to describe agreement, as in nodding your head to say yes.

For the CP Rail M & M Sub., it refers to the way visitors nod their heads to get into the layout room.

My first layout, the CP Rail Grimm Valley Subdivision, was a traditional around the walls, or donut style, layout. Entry was gained to the donut “hole” by crawling about three feet underneath the benchwork.

Suffice to say, it was no fun, not to mention undignified, and I think I still have the scars on my back from coming up too early.

As a result, I was determined not to have any duckunders in my new layout. But a nod-under? That would be OK.


The lower level, with the swinging gate closed.

The upper level is about 62 inches high at the entrance to the layout room (157 centimetres for us Canadians). For all but the tallest adults, it means that people only need to nod their heads to enter the room.

That said, when visitors come over I put a paper sign on the nod-under that says "Duck!" It hangs an inch or two below the bottom of the upper level so that people can feel the paper if they don't nod far enough, or come up too early on the other side.

The lower level is about 43 inches high (109 centimetres); only a limbo dancer could get under that! For this reason, I built a swinging gate so people can get in and out of the room unimpeded.

Originally, it was just going to be a piece of 2 by 4 with track on it. But then a friend offered me a fabulous bridge, so I dropped the 2 by 4 about four inches and redesigned the gate to represent a river.

A simple bolt holds the gate in place, and joiners are slipped over the tracks to align them on the far (non-swinging) end.

On the swinging end, they simply line up with the track on the benchwork. Wires carry electricity to the tracks on the bridge.

Why a swinging bridge and not a lift-out? The main challenge with a lift-out is that, after you lift it out, you have to put it someplace. The swinging bridge simply swings out of the way and stays there.

(A drop-down or lift-up bridge would do the same thing; in fact, I use a drop-down bridge across the door to the storage room.)

If you come to see the M & M Sub., it's OK with me if you nod-off. In fact, I prefer it to banging your noggin' on the upper level benchwork!

2 comments:

  1. Hi John,

    Nice post on the nod-under. I also had a former donut-shaped layout and one visitor, a senior but solid Presbyterian minister came for a visit, came up too early, and that whole part of the layout rose an inch or so off the floor! Fortunately, he was OK.

    My G-shaped switching layout is walk-in, but my recent change of locale from Winnipeg to Vancouver came with the addition of a continuous-run option, which uses a "drop in" section.

    Question: How do you coordinate visitors entering/leaving the room when the lower level is operating and the swinging gate is closed?

    Eric

    ReplyDelete
  2. Thanks for note, Eric.

    During operations, the gate can be closed since once we're all in, we're in. If someone needs to leave for any reason, he or she can simply open and close the gate.

    For open houses, when people are coming and going all the time, I leave the gate open and only run trains from the Fort Frances yard to the upper level staging yard. Since the run from that point to the upper level staging yard is about 8 minutes, there's still lots of time to watch a train in action.

    ReplyDelete